Opticraft Community
Discussion forum => Legacy => Archives => Support => Topic started by: Pensfan121 on November 25, 2012, 03:13:37 pm
-
I have gotten signaturecraft and don't know how to put it in my profile. Can someone please post an example of how to do this.
-
You copy the forum BBcode, not the url.
Example: http://i.imgur.com/pXlfY.png
-
where do i copy it to
-
You go to your profile, and then click on Forum profile information.
Image: http://i.imgur.com/1XzwW.png
Then you scroll down to the signature box.
Image: http://i.imgur.com/re4RM.png
Paste it there.
-
ok
-
like this
...
nope isnt showing up
-
You might have forgot to press the 'change profile button' at the bottom right.
http://i.imgur.com/Py1i6.png
-
ok
-
i dont see the profile change button
-
Here: http://i.imgur.com/MFPer.png
-
Did you wrap it around with the image code?
-
Did you wrap it around with the image code?
I was about to ppost that xD.
Anyway, before the pic do [img] and after do [ / img]
-
i dont see the profile change button
i think i see the problem. as i had the same thing.
It could be that your signature is so long, it pushes out on the box, but there is no scroll bar. What you need to do is click on some box on the change profile page, and press TAB until you can't see the dotted lined around the box, then press enter. Usually, the button gets pushed off the page, so you can't click on it. This has happened before, here is a better, less-complicated instruction:
'
I believe you can also just hit the "Enter" button on your keyboard. Works on my laptop, and I'm not sure if it would be set up differently on other computers. You may have to use the "Tab" button a few times, and then hit enter.
-
I got it the profile button didn't show up on one computer but did on the other thanks so much. Also staff can lock this topic.