Opticraft Community
Discussion forum => Legacy => Archives => General Discussion => Topic started by: Tree Frog on April 09, 2012, 01:27:03 am
-
Anyone have a suggestion for trouble shooting a set of pistons that gets set in the "open" position? I have 6 rows in the auto-farm that work and this one that stays as if they are always powered on. All the others work normally.
This one row stays activated even when I completely disable the entire redstone circuit.
This row is on the same power feed as a second set of pistons on the other side. Those work fine.
Any ideas?
-
I have issues with pressure plates sticking down.
It's probably a chunk loading and unloading thing.
-
I had this same problem, turned out it was a red stone torch 1 block under that i misplaced.
-
Thanks Smite. I checked for bleed over from something else and can't find anything. It's really odd because pistons equally far away from these are working.
Nyssa - is there anything I can do about that or is it just a permanent "deadzone" in my autofarm? I've removed and replaced them several times but that doesn't seem to help.
I'll assume it's just a deadzone unless someone has an idea.
Thanks for any suggestions!
-
Thanks Smite. I checked for bleed over from something else and can't find anything. It's really odd because pistons equally far away from these are working.
Nyssa - is there anything I can do about that or is it just a permanent "deadzone" in my autofarm? I've removed and replaced them several times but that doesn't seem to help.
I'll assume it's just a deadzone unless someone has an idea.
Thanks for any suggestions!
hmm something similar happend to me before, my sticky piston which has 30 signs attached to a wooden plank infront of it refuses to pull back... even when theres no red stones near it.. xp